03 Module - software for MMC flasher (Lancer X1.5, Outlander JDM)

03 Module - software for MMC flasher (Mitsubishi Lancer X1.5, Outlander JDM)
- Read Calibration Data
- Write Calibration Data
- Read full image data
- Write full image data 
- ID Identification
- Read/write errors
- Read/write configuration data
- Calculate the checksum

Supported:
MH8104F_(512K) by CAN, MH8104F_(512K) by K-line (repair/recovery), 
MH8106F_(1024K) by CAN,  MH8106F_(1024K) by K-line (repair/recovery), EVO X ACD m32r (512K) by K-line

Added the ability to read and write coding, and reading and writing the Vin number.
The module is able to display information about the version ON the ECU, VIN number, hardware implementation, UNIT and recalculate the checksum.
As well as restore the Unlock button after unsuccessfully attempting to read/write with ECUFLASH program.
Available recalculating the checksum.
Series processors used in the M32r ECU Mitsubishi software and restored from any state in line with the built-in bootloader.

It works via a J2534 compatible adapter (Sold separately).
Note: the modules cannot be deactivated. If you provide the wrong dongle number, no refund will be possible.
Attention ! In case of the dongle loss, the module transfer is not possible. You have to buy a dongle and software again.

More information (in English) mmcflash.eu
More information (in Russian) mmcflash.ru